Workbench legs – But easy or difficult your hobby or home improvement project, you’ll need a workbench to do it. A good bench is heavy and sturdy enough to remain stationary during drilling, cutting or hammering on it and survive years of wear. You can make a workbench that is robust, cheap and convenient by extending studs left over from other projects. You can use either 2 by 4 or 2 by 6 studs. Cut four 34 3/4-inch lengths of the studs. These are the legs of the workbench. Cut four 55-inch lengths. This is your long lateral braces. Measure the width of the studs. A 2-by-4’s never exactly four inches wide and a 2-by-6 are never exactly 6 inches wide. Share width measurement of the 26. Round up. Note this number “A” and then multiply it by the width of the studs. Cutting four lengths of stud equal to this length. These are the short side braces.
Workbench legs, use screws to attach one of the short side braces to one end of one of the legs so as to form an L shape. The attachment of the second leg to the second end of the brace to form a U-shape. Attach the other pair of legs together in the same way. The braced ends of the legs are peaks, the free ends of the bottoms. Measure 6 inches from the bottom of each leg and make a mark with a pencil. Add the other short side braces on his legs so that the bottoms of braces are on the mark. Screw these braces to the legs. Make sure that these braces are on the same side of the legs of the other braces. You should now have two pairs of legs, each pair held together by two short braces.
Place two pairs of workbench legs up so that the braces are on the sides facing the other pair. Screw two of the long side braces to the sides of the pair of legs so that each pair is connected to the other of the long braces. Make sure that these long braces put on a level with the lower pair of short suspenders. You should now have the rough framework of a box. Measure the width of the studs. Multiply this width by 2. Subtract score 55. Label result of this, in inches, “B.” Cut “A” studs with length “B.” Put them on the lower braces and screw them on the lower braces. You now have a lower shelf on the workbench.Tags:work bench legs