Wood coffee tables – Coffee is a project that you can do if you know about the use of drills and wood. Coffee can be made with storage if you want a place to put mail, newspapers or other paper for quick reference later by adding a box to it. The coffee table drawer is built similar to the table itself. Place 34-inch lumber with the narrow sides vertical. Line up the boards to be 4 meters apart and parallel to each other. Do the ends flush. Place the 4-foot timber on each side of the 34-inch discs. Set sides of the 4-foot board against the ends of the shorter boards. Put the 5-inch wafers in the other end of the 34-inch disks with sides of 5-inch wafers flush against the ends of the 34-inch discs. Drill screws through the sides of the 4-foot board and the 5-inch wafers in the ends of the 34-inch discs.
Set the plywood over the frame with the edges flush to the frame. Screw a small screw in each corner of the plywood to the frame. Measure and mark a point every 6 inches on each side. Set screws through the plywood into the frame at these points to finish tabletop. Rolling table top so that the frame is at its peak. Put a post at the inner corner of the frame so every corner has a post. Use the larger screws to connect the wood coffee tables legs. Drill screws through the frame into the frame with two screws on each side of a post.
Put the 37 1/2 inch sheets in parallel with the narrow vertical sides. Set a two foot distance between them. Put a 33 1/2-inch board in each end of the longer boards. Have sides of the longer boards flush with the ends of the short boards. Fasten the frame with short screws by drilling through the sides of the long boards at the ends of the short boards. Place the smaller piece of plywood over the frame. Align the sides. Measure and mark the spots was 6 inches on each side. Use short screws drilled into plywood at each mark to secure drawer base. Put a slider at the top of the 33 1/2 sides of the box. Make the outer edges of the runners flush with the outer edges of the box. Use ready-made holes in the runners with short screws to secure the runner to the drawer base. Line up matching runner bits on the bottom of the table top to match the box. Attach these runners in the same way. Attach the handle or knob to the center of the front of the box. Slide the drawer in the wood coffee tables.