Folding bar table – When space is limited, or if you just want an extra area installed in a room, building a folding table that attaches room’s wall. With folding brackets, table attach to wall studs, creates a surface that can carry a lot of weight. When not needed the table, simply fold down so it takes up only a few inches to Walls surface. How to build a folding bar table that connects to a wall. Mark a line across the wall with a pencil that s required width of the table, at the height where you want the table top. Measure the length of the line with a tape. Transfer the measurement to the piece of wood that you want to create your tabletop, using the measurement to set the table the length of a pencil. Determine the width you want for the table top and place a mark on the timber at the desired width, too.
Then to build a folding bar table that connects to a wall. Cutting the wooden board along the marked lines using a table saw. Sand smooth edges with means sandpaper. Dry sanding residue from the wood. Stain or painting the wood color desired. Use a paintbrush to apply wood stain to the desk, brushing the stain on the surface of the wood in rows along the wood grain. Allow the stain to sit for 15 minutes to penetrate the wood, and then remove any excess stain left on the surface with a clean cloth.
Apply a strip of wood veneer trim to the table edges to keep the wood cracks along the edge using. Brush a layer of construction adhesive on the edges of the table top and the back of a piece of plywood cut to fit to the edges. Let the glue dry until it loses its moisture, but is still sticky, and then press the veneer pieces on the sides of the table. Find the wooden studs in the wall along the marked line by means of a detector rule. Mark the stud locations, and then measure the distance between the sites of the outer studs on each end of the folding bar table.