Glass top pedestal dining table – To make the structure, we will need an iron tube of about 60 X 60 mm, from which we will get four pieces for each leg and crossbar. Using the technique of arc welding, we join the tubes together and give color to the metal surface. After putting on the self-adhesive lids and tears, we set the countertop. We mark and cut the pieces of iron, using the mini-grinder and a disc to cut metal. It is advisable to protect both hands and eyes with strong gloves and glasses. Replace the cutting disc with a roughing disk and we go over the cutting areas until the surface is even. Next, we present the four pieces that will form one of the legs on a flat surface and hold them with squares.
Then to design for glass top pedestal dining table, we connect the welder, we primed the electrode and we give welding points in the areas of union. Afterwards, we bite and remove the slag, using a barbed wire brush. Check that the iron tubes are square and give the final weld bead. It is important to protect your face well, especially the eyes, with a grimace. Let’s review the joints again with the miniaturize until the surface is even and polished. To perform this task, we change the roughing disk by one to polish. In the same way we mount the other leg and join the two by a crossbar. With the structure completely finished, clean the iron surface with a rag moistened with alcohol and dries it.
Next, apply spray enamel, in this case white, respecting the minimum distance that the manufacturer tells us. To get a better finish, it is better to give several thin coats of paint than a coarse one. When the product has dried, put the covers to hammer blow and put the self-adhesive tears. Finally, we put the worktop, in this case of glass, well centered, on the structure. In this simple way and using the technique of arc welding, we have achieved a glass top pedestal dining table design, elegant, perfect for the dining room, for example.